All Punch And All Clear; Cube Automation Editing - Euphonix MixView CS3000 Software Manual

Section 2: Monitoring Enhancements

All Punch and All Clear

SIDE NOTE:
When automating Aux Sends
or Panners, there is no DSC
object key specifically
designated to arm punch-ins.
CUBE Automation
3.2
Editing
Panners 1-8 for channel #24 (Lower Fader Block only) are selected for edit operation
1 - 20
You can place multiple panner parameters into record by pressing the right-
most Special function (All) Punch key:
i d t
i d t
i d t
It is important to note that only those panner parameters which are currently
active are punched into record. This is a very convenient feature allowing you
to repeatedly punch those panner parameters needing updating. The (All)
Clear key resets all panner parameters to their default positions.
Editing CUBE Aux Send and Pan automation data operates in a slightly differ-
ent manner from editing standard desk automation. Normally, each individual
desk object (fader, mute, EQ, etc.) can be edited separately. CUBE Automation
Editing operates on a more global scale (individual Pan and Aux moves are not
editable) and is mainly intended for overall time insert and cut manipulation.
For a one-per-channel CUBE, any edit will affect console Lower Fader Block
Auxes 1-12 simultaneously and Panners 1-8 (of 16) simultaneously for each
console channel. Please refer to the CS3000 Manual for information on CUBE
Setup. The following figure shows a one-per-channel CUBE setup:
Total Panners selected = 8
Euphonix CS3000/2000 MixView 3.2 Software Supplement
i d t i d t i d t
i d t i d t i d t
i d t i d t i d t