Cutting Automation Moves - Euphonix MixView CS3000 Software Manual

Panners 1-8 for channel #24 (Upper Fader AND Lower Fader Blocks) are selected for edit operation
Cutting Automation
Moves
Pass
Ctrl
Pass 0
F1
Clr?
F1
Start
(red)
Euphonix CS3000/2000 MixView 3.2 Software Supplement
For a two-per-channel CUBE, the same rules apply but editing also affects
both console Upper and Lower Fader Blocks simultaneously. This is an impor-
tant distinction. The following figure shows a two-per-channel CUBE setup:
Total Panners selected = 16
To begin editing CUBE Aux automation you must define the edit's Start and
End times. Be sure you have a Title loaded and some CUBE automation written
to the source channel, then press the DSC [Pass Ctrl] key, [F4] (down arrows),
[F3] (Edit) and then [F4] (T/C):
Undo? Redo?
F2 F3 F4
Pack? Edit Util
F2 F3 F4
Section 2: Monitoring Enhancements
COPY? [Yes] Tplt
F1 F2 F3
Start: 00:00:00.00
F1 F2 F3
Automation
T/C
Edit Menu
F4
Cue
F4
End
(green)
1 - 21