Electrolux ICON appliances Design Manual page 90

I/P Vent Hood
RH36PC60GS
planning
information
For 36" model:
RH36PC60GS
Note: For planning
purposes only. Refer
to Product Installation
Guide on the web at
electroluxicon.com for
detailed instructions.
Specifications subject
to change.
Optional
Accessories
Duct-Free Kit
PN # RHDFP60GS
90
cooking
Island Vent Hoods
PRE-INSTALLATION CALCULATIONS
K = Kitchen height
C = Counter height
S H
P = Preferred height
of hood bottom
above counter
A
(24"- 30"
allowed, NOT
more than 36"
K P
recommended)
A = Canopy height
H = Hood height for
Counter Height
installation
36" standard
H = K-C-P
C
S = Chimney
structure height
for installation
S = H-A
2 / "
11
16
Top
Wiring box
Controls
Installation Specifications
• Product Weight – 84 Lbs.
• Island / Peninsula Ceiling-Mount Installation
• Ventilation system is preset to exhaust air outside. If
outside ducting is not possible, optional Duct-Free Kit
(PN # RHDFP60GS) is available to convert ventilation to
allow air to recirculate inside. (Refer to Ducted Option
Specifications for outside ventilation.)
• Sones Rating – 9.9
• Voltage Rating – 120V / 60 Hz / 15 Amps
• Connected Load (kW Rating) @ 120 Volts = 0.516 kW (For
use on adequately wired 120V, dedicated circuit having
2-wire service with a separate ground wire. Appliance
must be grounded for safe operation.)
• Amps @ 120 Volts = 4.16 Amps
• Always consult local and national electric codes. Check
local building codes for installation requirements, as they
may vary per locale.
• Minimum installation height allowed from bottom of hood
to cooking surface is 24" - 30" for electric and 30" for gas.
(NOT more than 36" recommended.)
• To prepare mounting surface, adequate structure and
support must be provided, capable of supporting 150 lbs.
12 1 / "
8
35 / "
7
8
Air outlet -
7 7 / " diam.
8
Ducted Option Specifications
• For outside ventilation.
• Exhaust Duct Required – 8" round
• For most efficient airflow exhaust, use a straight run or as
few elbows as possible.
• Use metallic flex ducting only to connect rigid duct directly
to transitions (if allowed by code).
• Thermal breaks such as short section of nonmetallic duct,
should be used in areas of extreme cold.
• Cold weather installations should have additional
backdraft damper installed.
• Refer to installation instructions on web for detailed
exhaust duct preparation and converting vent blower
system for recirculating inside.
Pre-Installation Calculations
• Select hood preference height (P) that is comfortable
for user (24" - 30" minimum allowed, NOT more than
36" recommended).
• Calculate hood height (H) for installation (H = K-C-P).
• Confirm that (H) is within minimum to maximum range for
hood. If not, adjust installation.
• Calculate chimney structure height (S). Use formulas,
check dimensions of hood. Save calculation for use later
in installation.
13 / "
3
16
min.
max.
Dimensions
from base of
hood to ceiling,
and include
clearance
required for
28"
installation.
( min.
height
with one
cover)
25 / "
3
16
35"
57"