Electrolux ICON appliances Design Manual page 158

Under-Counter Installation
planning
information
For models:
Cooktop
E30GC70FSS
E36GC70FSS
Single Wall Oven
E30EW75GPS
E30EW75GSS
Note: For planning
purposes only. Refer
to Product Installation
Guide on the web at
electroluxicon.com for
detailed instructions.
Specifications subject
to change.
158
project planning
Gas Cooktop Installation Over 30" Electric Single Wall Oven
For all approved gas cooktop models, a minimum
height opening of 6-1/2" (from top of counter) required
in right cabinet side panel and/or filler panel, to route
gas and electric hookups. (Refer to Gas Cooktop
Utility Hookup Diagram)
Side filler panels necessary to isolate oven from
adjoining cabinets. Panel height may need to
be modified to accommodate the depth of approved
gas cooktop models
Electric Single Wall Oven Cutout
For models: E30EW75GPS
& E30EW75GSS
Approx. 3"
240/208V
Junction box
for wall oven
24" min.
cutout depth
4-1/2" maximum height allowed
from oven base to floor if cooktop
is installed directly over wall oven.
(5" maximum height allowed
with no cooktop.)
Installation Specifications
30" Electric Single Wall Oven
Under-Counter Installation Specifications
• Product Weights –
(E30EW75GPS) 178 Lbs. / (E30EW75GSS) 175 Lbs.
• Single phase 3- or 4-wire cable, 120 / 240 or 120 / 208
Volt, 60 Hertz AC only electrical supply with ground
required on separate circuit fused on both sides of line.
• Connected Load (kW Rating) @ 240 / 208 Volts =
4.0 / 3.0 kW
• Amps @ 240 / 208 Volts = 16.6 / 14.4 Amps
• Always consult local and national electric and gas codes.
• Minimum 23-1/4" clearance for oven door depth
when open.
• Minimum 24" deep cutout dimension is critical for
proper installation, to ensure that oven's faceplate will fit
flush against cabinet front.
• Full oven base of solid plywood or similar material required,
capable of supporting 200 Lbs. Install over two runners
and flush with toe plate.
• Base must be level and cabinet front must be square
with finish-cut bottom edge.
• Side filler panels necessary to isolate oven from adjoining
cabinets.
• Allow 5" maximum height from oven base to floor, if NO
cooktop is installed directly over wall oven.
Cooktop
120V/60Hz
grounded
outlet, for
Manifold
gas cooktop
pipe
Flare union
Flexible connector
Pressure regulator
Cabinet sides
and/or filler panel
Cooktop
cutout**
24"min.*
28 / " min.
1
2
29" max.
Install / " full plywood base on 2 runners, flush
3
4
with toe plate, capable of supporting 200 lbs.
Unit will overlap cutout (minimum) edges by 1"
To route armored cable to junction box through left cabinet side panel
and/or filler panel, cut minimum 4" x 4" opening in wood base and runner
Gas Cooktop Installation Over
30" Electric Single Wall Oven Specifications
Electrolux ICON
and E30EW75GSS are approved to be used beneath
Electrolux ICON
E30GC70FSS (gas cooktop models NOT approved for
use in this installation are E36GC75GSS, E48GC76EPS,
E36GC76GPS and E30GC74GPS).
For detailed Gas Cooktop installation, refer to model-specific
Planning Information page and installation guide on web.
• Side filler panels necessary to isolate oven from adjoining
cabinets. Panel height may need to be modified to accom-
modate the depth of approved gas cooktop models.
• Minimum height opening of 6-1/2" (from top of counter)
required in right cabinet side panel and/or filler panel, to
route gas and electric hookups.
• Allow 4-1/2" maximum height from oven base to floor,
if cooktop is installed directly over wall oven.
18" max.
4"
6 / "
1
2
5"
min.
Flare
union
120V/60Hz
grounded outlet
Manual shutoff valve
(Must be accessible)
Side View
Oven cutout
Cooktop
36"
min.
28 / " min.
1
2
28 7 / " max.
8
Wall Oven
® Single Wall Oven models E30EW75GPS
®
gas cooktop models E36GC70FSS and
Countertop
Gas
Cooktop
Utility
Hookup