Table of Contents
Advertisement
Dual-Fuel Freestanding Ranges
Installation Specifications
•
Product Weight – 250 Lbs.
•
Single phase 3- or 4-wire cable, 120 / 240 or
120 / 208 Volt, 60 Hertz AC only electrical supply
with ground required on separate circuit fused
on both sides of line.
•
Connected Load (kW Rating) @ 240 / 208 Volts =
6.5 / 4.8 kW
•
Amps @ 240 / 208 Volts = 27 / 23 Amps
•
Recommended Circuit Breaker – 30 Amps
•
Always consult local and national electric and
gas codes.
•
Range ships with 3/4" factory regulator.
•
LP Gas conversion kit supplied.
•
Overhead cabinetry should not exceed a 13"
maximum depth.
•
Allow 30" minimum clearance between top of rangetop
and bottom of unprotected wood or metal overhead
cabinetry.
•
Absolute minimum horizontal distance between overhead
cabinets installed to either side of appliance must be no
less than maximum width of appliance.
•
Allow 7" minimum clearance from edge of rangetop to
nearest combustible wall on either side of unit.
•
Allow 24" minimum clearance when bottom of wood or
metal overhead cabinet is protected by not less than
1/8" flame-retardant millboard covered with not less than
No. 28 MGS sheet steel, 0.015" stainless steel, 0.024"
aluminum or 0.020" copper.
•
To reduce risk of fire when using overhead cabinetry,
install vent hood that projects horizontally a recommended
minimum of 5" beyond bottom of cabinets.
e l e c t ro l u x i c o n . c o m
planning
information
For 30" model:
E30DF76GPS
Note:
For planning
purposes only. Refer
to Product Installation
Guide on the web at
electroluxicon.com for
detailed instructions.
Specifications subject
to change.
Optional
Accessories
9" Stainless
Steel Backsplash
PN # 903104-9010
12" Stainless
Steel Backsplash
PN # 903105-9010
Stainless Steel
Island Trim Kit
(for use in place
of backsplash)
PN # 903106-9010
4" Stainless
Steel Kick Plate
PN # 318352601
Black Knobs Kit
PN # 903108-9010
11
Hide quick links:
Advertisement
Table of Contents
