E30So75Fps E30So75Ess - Electrolux ICON appliances Design Manual

E30SO75FPS
High-Speed Ovens
30"
/ "
11
16
22 / "
7
8
Allow at least
12" clearance
for door depth
when open
**When used in combination with another
Electrolux ICON
clearance of 2
High-Speed Oven cutout to top edge of
companion product's faceplate, leaving a 2"
visible gap between both product faceplates
Installation Specifications
• Product Weight – 115 Lbs.
• Voltage Rating – 240V / 60 Hz / 15 or 20 Amps
• Single phase 3- or 4-wire cable, 240 Volt, 60 Hertz AC
only electrical supply with ground required on separate
circuit fused on both sides of line.
• Connected Load (kW Rating) @ 240 Volts = 3.3 kW
• Amps @ 240 Volts = 13.2 Amps
• Oven has a 6-15 plug, requiring a 6 -15 receptacle.
• Always consult local and national electric codes.
• Minimum 12" clearance for oven door depth when open.
• Minimum 22-3/4" deep cutout dimension is critical for
proper installation, to ensure that oven's faceplate will fit
flush against cabinet front.
• Full oven base of solid plywood or similar material
required, capable of supporting 150 Lbs.
• Base must be level and cabinet front must be square.
• Grounded outlet should NOT be located in shaded
area, as indicated.
Power supply location
(left bottom rear)
21 / "
1
4
21 / "
7
32
23 / "
5
8
distance
/ "
5
8
built-in product, a minimum
®
/ " required from bottom of
5
8
24" min.
21 / "
3
8
min.
22 / " min.
21 / " 3
7
8
8
22 / " max.
max. 7
8
2"(visible
gap)**
dimension)
36"min.
required
to floor
Combination Installations
For installation details refer to Project Planning Section.
• Oven is NOT approved to be used under counter.
• Oven can be built in alone or is approved to be used
in combination with any Electrolux ICON
Oven and / or Warmer Drawer. (Refer to model-specific
Combination Installation Specification pages.)
• When used in combination with another Electrolux ICON
built-in product, a minimum clearance of 2-5/8" required
from bottom of High-Speed Oven cutout to top edge
of companion product's faceplate, leaving a 2" visible gap
between both product faceplates.
e l e c t ro l u x i c o n . c o m
30" min.
C L
20 / "
1
4
16 / "
3
4
240V/60Hz
grounded
electrical
22 / "*
3
4
outlet should
(critical
NOT be located
within shaded
area
Full base
required
to support
150 lbs.
®
Single Wall
®
planning
information
For models:
E30SO75FPS
E30SO75ESS
Note: For planning
purposes only. Refer
to Product Installation
Guide on the web at
electroluxicon.com for
detailed instructions.
Specifications subject
to change.
Installation drawing shown
with professional series model.
61