planning
information
For model:
E24CM75GSS
Note:
For planning
purposes only. Refer
to Product Installation
Guide on the web at
electroluxicon.com for
detailed instructions.
Specifications subject
to change.
Optional
Accessories
Cleaning Kit
PN # ACCKIT-24
Decalcification Kit
PN # ACCKITA-24
144
E24CM75GSS
specialty
Built-In Coffee Maker
Installation Specifications
•
Product Weight – 110 Lbs.
•
Voltage Rating – 120V / 60 Hz / 20 Amps
•
Connected Load (kW Rating) @ 120 Volts = 1.8 kW
(For use on adequately wired 120V, dedicated circuit
having 2-wire service with a separate ground wire.
Appliance must be grounded for safe operation.)
•
Amps @ 120 Volts = 20 Amps
•
Recommended electrical outlet location should be in an
adjacent cabinet, for accessibility after installation.
•
Always consult local and national electric codes.
•
Unit not approved for use in a freestanding cabinet.
•
Full base of solid plywood or similar material required,
capable of supporting 125 Lbs.
•
Base must be level and front of cabinet square for proper
operation.
•
Allow at least 24" clearance with front panel in 90° open
position.
•
To allow for proper ventilation, a minimum opening of 4" H
x 12" W required at back of cabinet, near top of cutout.
•
Steam barrier supplied for installation.
•
Install unit at a safe distance from any heat source, such as
other appliances, to avoid excessive rises in temperature.
•
A water treatment system may need to be installed for
this unit if water hardness level exceeds 4 grains per
gallon. A reverse osmosis system is not recommended,
since it may reduce water pressure. (Use filtered water
only. Do NOT use distilled water.)
•
Use of optional Cleaning Kit (ACCKIT-24) and
Decalcification Kit (ACCKITA-24) is strongly recommended
to help prevent mineral buildup and maintain proper
operation of unit.