Electrolux ICON appliances Design Manual page 95

Downdraft Vents
Studwall
Wallboard
Installation Specifications
• Voltage Rating – 120V / 60 Hz / 15 Amps
• Connected Load (kW Rating) @ 120 Volts = 1.0 kW
(For use on adequately wired 120V, dedicated circuit
having 2-wire service with a separate ground wire.
Appliance must be grounded for safe operation.)
• Amps @ 120 Volts = 8.0 Amps
• Do not use same circuit as cooktop.
• Always consult local and national electric codes.
Check local building codes for installation requirements,
as they may vary per locale.
• Vent must be installed in vertical orientation only.
• Vent unit outside of building only.
• Exhaust Duct Required – 3-1/4" x 10" (3-1/4" x 10" to
round transition duct will be needed)
• Do not use flexible duct. Round duct instead of rectangular
duct recommended, especially when elbows are required.
• When multiple elbows are necessary, ensure a minimum
of 24" of straight duct between any two elbows.
• Thermal breaks such as short section of nonmetallic duct,
should be used in areas of extreme cold.
• For most efficient airflow exhaust, use a straight run or
as few elbows as possible.
• Cold weather installations should have additional backdraft
damper installed.
/ " max.
3
4
backsplash
thickness
/ " min.
1
4
2 / "
1
8
Cooktop/
3"
Range
1 15 / "
16
/ "
9
32
2 / "
13
16
Vent unit
Motor cover
Remote Exhaust Blower
• 1,600 CFM Remote Exhaust Blower (PN # 5304444802)
included with vent – shipped in separate box.
• Installation Options – roof or exterior wall mount for
against-wall vent installation and under-floor mount for
island vent installation.
Combination Installations
For installation details refer to Project Planning Section.
• Installing a Downdraft Vent in combination with any gas
cooking surface will affect optimum burner efficiency.
• Downdraft Vents can NOT be used in combination with
any cooktop backsplash.
• Downdraft Vent model E30DD75ESS is approved to
be used in combination with Electrolux ICON
models E30EC65ESS, E30EC70FSS, E30IC75FSS,
E30IC80ISS, E30GC64ESS, E30GC70FSS and
E30GC74GPS. (For detailed countertop preparation,
refer to Drop-In and Slide-In Cooktop / Downdraft Vent
Countertop Preparation pages.)
• Proper combination installation of Electrolux ICON
Downdraft Vent model E30DD75ESS and approved
30" Gas Slide-In Cooktop will require cooktop power cord
to be relocated to underside of unit. (For details, refer to
30" & 36" Gas Slide-In Cooktop Power Cord Relocation
Instructions page or on the web at electroluxicon.com.)
®
Cooktop
®
e l e c t ro l u x i c o n . c o m
planning
information
For 30" model:
E30DD75ESS
Note: For planning
purposes only. Refer
to Product Installation
Guide on the web at
electroluxicon.com for
detailed instructions.
Specifications subject
to change.
95