Electrolux ICON appliances Design Manual page 22

planning
information
For models:
E30EW85GPS
E30EW85GSS
Note: For planning
purposes only. Refer
to Product Installation
Guide on the web at
electroluxicon.com for
detailed instructions.
Specifications subject
to change.
Installation drawing shown
with professional series model.
22
cooking
Electric Wall Ovens
30"
28
/ "
7
8
29 / "
1
4
Spacer
Allow at least
23 / " clearance
1
4
for door depth
24
when open
Installation Specifications
• Product Weights – (E30EW75GPS) 178 Lbs. /
(E30EW75GSS) 175 Lbs.
• Single phase 3- or 4-wire cable, 120 / 240 or
120 / 208 Volt, 60 Hertz AC only electrical supply with
ground required on separate circuit fused on both
sides of line.
• Connected Load (kW Rating) @ 240 / 208 Volts =
4.0 / 3.0 kW
• Amps @ 240 / 208 Volts = 16.6 / 14.4 Amps
• Always consult local and national electric codes.
• Minimum 23-1/4" clearance for oven door depth
when open.
• Suggested distance from floor is 31". Minimum required
distance is 4-1/2".
• Minimum 24" deep cutout dimension is critical for proper
installation, to ensure that oven's faceplate will fit flush
against cabinet front.
• Full oven base of solid plywood or similar material
required, capable of supporting 200 Lbs.
• Base must be level and cabinet front must be square
with finish-cut bottom edge.
1 / "
1
2
min.
/ "
1
4
28 / "
1
2
min.
28 / "
7
8
max.
27 7 / "
8
31"
/ "
5
8
suggested
distance
4 / "
1
2
min.
required
Combination Installations
For installation details refer to Project Planning Section.
• Single Wall Ovens are NOT approved to be used in
stackable or side-by-side installation.
• Single Wall Ovens are approved to be used alone in
under-counter installation or beneath Electrolux ICON
gas cooktop models E36GC70FSS and E30GC70FSS;
and Electrolux ICON
E36IC75FSS, E30IC75FSS, E36IC80ISS, E30IC80ISS,
E36EC70FSS and E30EC70FSS. (Refer to Gas or
Electric Cooktop Installation Over 30" Electric Single
Wall Oven page.)
• Gas and electric cooktop models NOT approved for
use in this installation are E36GC75GSS, E36EC75ESS,
E36EC75HSS, E48GC76EPS, E36GC76GPS,
E30GC74GPS, E30EC65ESS and E36EC65ESS.
• Single Wall Ovens are approved to be used in
combina tion with any Electrolux ICON
(For Combination Installation Specifications refer to model-
specific Warmer Drawer Planning Information page.)
• Single Wall Ovens are approved to be used in combina-
tion with any Electrolux ICON
Built-In Microwave. (Refer to model-specific Combination
Installation page.)
30" min.
24" min.*
28 / " min.
1
2
(critical
29" max.
dimension)
2" min.
Bottom cutout
edge must be
finish cut
®
electric cooktop models
® Warmer Drawer.
®
High-Speed Oven or
4" x 4"
opening
to route
armoured
cable
Full base
required
to support
200 lbs.
3"
Electrical
junction
box location
®