Electrolux ICON appliances Design Manual page 52

Electric Cooktop
E30EC70FSS
planning
information
For 30" model:
E30EC70FSS
Note: For planning
purposes only. Refer
to Product Installation
Guide on the web at
electroluxicon.com for
detailed instructions.
Specifications subject
to change.
Optional
Accessories
Granite Countertop
Installation Kit
PN # 903061-9010
52
cooking
Electric Cooktops
13"
max.
cabinet
depth
1 / " min. recommended
1
2
distance between rear
4"x 8" opening to route
edge of cutout and
armored cable
nearest combustible
surface above countertop
20 / " min.
1
8
20 / " max.
1
4
25"min.
24"
2 1 / " min. from edge of cutout
2
to front edge of countertop
Installation Specifications
• Product Weight – 42 Lbs.
• Single phase 3- or 4-wire cable, 120 / 240 or 120 / 208
Volt, 60 Hertz AC only electrical supply with ground
required on separate circuit fused on both sides of line.
• Connected Load (kW Rating) @ 240 / 208 Volts =
7.8 / 5.9 kW
• Amps @ 240 / 208 Volts = 33.0 / 29.0 Amps
• Recommended Circuit Breaker – 40 Amps
• Always consult local and national electric codes.
• Allow 2" space below armored cable opening to clear
electrical cable and allow space for installation of junction
box on wall at back of cooktop.
• Overhead cabinetry should not exceed a 13" max. depth.
• Allow 30" minimum clearance between top of cooktop
and bottom of unprotected wood or metal overhead
cabinetry.
• Absolute minimum horizontal distance between overhead
cabinets installed to either side of appliance must be
no less than maximum width of appliance.
• Allow 24" minimum clearance when bottom of wood or
metal overhead cabinet is protected by not less than
1/8" flame-retardant millboard covered with not less than
No. 28 MGS sheet steel, 0.015" stainless steel, 0.024"
aluminum or 0.020" copper.
30 / "
3
4
21 1 / "
2
30 / "
3
4
10"
5" min.
12"
Approximate location
of junction box
• Allow 1-1/2" minimum clearance between rear edge
of cutout and nearest combustible surface above
countertop.
• Allow 7-1/2" minimum clearance from edge of cooktop
to nearest combustible wall on either side of unit.
• Drawers not recommended beneath cooktop.
• To reduce risk of fire when using overhead cabinetry,
install vent hood that projects horizontally a recommended
minimum of 5" beyond bottom of cabinets.
Combination Installations
For installation details refer to Project Planning Section.
• Cooktop model E30EC70FSS is approved to be used
over any Electrolux ICON
Electric Cooktop Installation Over 30" Electric Single Wall
Oven Specifications page.)
• Cooktop model E30EC70FSS is approved to be used
in combination with an Electrolux ICON
Vent. (Refer to Drop-In Cooktop / Downdraft Vent
Countertop Preparation page for detailed installation
specifications.)
30" min. for
unprotected cabinet
24" min. for
protected surface
5"
18"
min.
7 / " min. to nearest
1
2
combustible wall
(either side of unit)
29 / " min.
7
8
30" max.
®
Single Wall Oven. (Refer to
®
30" Downdraft