Electrolux ICON appliances Design Manual page 44

Induction Cooktop
E30IC80ISS
planning
information
For 30" model:
E30IC80ISS
Note: For planning
purposes only. Refer
to Product Installation
Guide on the web at
electroluxicon.com for
detailed instructions.
Specifications subject
to change.
Optional
Accessories
Granite Countertop
Installation Kit
PN # 903061-9010
44
cooking
Induction Cooktops
13"
max.
cabinet
/ "
1
4
depth
4 / " to
3
8
service
panel
1 / " min. recommended
1
2
Approximate location
distance between rear
of junction box
edge of cutout and
nearest combustible
surface above countertop
20 / " min.
3
8
20 / " max.
1
2
25" min.
24"
2 / " min. from edge of cutout
1
2
to front edge of countertop
Installation Specifications
• Product Weight – 44 Lbs.
• Single phase 3- or 4-wire cable, 120 / 240 or 120 / 208
Volt, 60 Hertz, fused on both sides of line with ground.
• Connected Load (kW Rating) @ 240 / 208 Volts =
7.7 / 6.7 kW
• Amps @ 240 / 208 Volts = 32.0 / 32.0 Amps
• Recommended Circuit Breaker – 40 Amps
• Always consult local and national electric codes.
• Allow 2" space below armored cable opening to clear
electrical cable and allow space for installation of junction
box on wall at back of cooktop.
• Overhead cabinetry should not exceed a 13" max. depth.
• Allow 30" minimum clearance between top of cooktop
and bottom of unprotected wood or metal overhead
cabinetry.
• Absolute minimum horizontal distance between overhead
cabinets installed to either side of appliance must be
no less than maximum width of appliance.
• Allow 24" minimum clearance when bottom of wood or
metal overhead cabinet is protected by not less than
1/8" flame-retardant millboard covered with not less than
No. 28 MGS sheet steel, 0.015" stainless steel, 0.024"
aluminum or 0.020" copper.
30 / "
3
4
21 / "
1
30 / " 2
3
4
28 / "
7
8
19 / "
7
8
10"
4 / "
1
2
12"
4"x 8" opening
to route armored cable
Front
• Allow 1-1/2" minimum clearance between rear edge
of cutout and nearest combustible surface above
countertop.
• Allow 7-1/2" minimum clearance from edge of cooktop
to nearest combustible wall on either side of unit.
• Drawers not recommended beneath cooktop.
• To reduce risk of fire when using overhead cabinetry,
install vent hood that projects horizontally a recommended
minimum of 5" beyond bottom of cabinets.
Combination Installations
For installation details refer to Project Planning Section.
• Cooktop model E30IC80ISS is approved to be used
over any Electrolux ICON
Electric Cooktop Installation Over 30" Electric Single
Wall Oven Specifications page.)
• Cooktop model E30IC80ISS is approved to be used in
combination with an Electrolux ICON
Vent. (Refer to Drop-In Cooktop / Downdraft Vent
Countertop Preparation page for detailed installation
specifications.)
30" min. for
unprotected cabinet
24" min. for
protected surface
3"
18"
7 / " min. to nearest
1
2
min.
combustible wall
(either side of unit)
29 / " min.
5
8
29 / "max.
3
4
Side View
Countertop Countertop
Cooktop
3"
4 / "
3
8
/ "
1
Rear
4
7" 11"
Service panel
®
Single Wall Oven. (Refer to
®
30" Downdraft