Warmer Drawers
Stand-Alone Installation
23
/
" (not including
3
8
custom panel)
Mounting
panel
29"
10
Overall depth with
drawer fully extended
(excluding custom panel
and handle) – 41
/
"
1
2
Warmer Drawer /
Single Wall Oven
Combination Installation
Custom front panel with
custom handle (not included)
Installation Specifications
•
Product Weight – 41 Lbs.
•
Voltage Rating – 120V / 450W / 60 Hz / 15 Amps
•
Connected Load (kW Rating) @ 120 Volts = 0.45 kW
(For use on adequately wired 120V, dedicated circuit
having 2-wire service with a separate ground wire.
Appliance must be grounded for safe operation.)
•
Amps @ 120V = 3.75 Amps
•
Full plywood base required, capable of supporting
100 Lbs.
•
Base must be level and cabinet front must be square.
Custom Panel Specifications
•
Handle not included, match to custom cabinetry.
•
Panel Dimensions – 11-1/4" H x 30" W x 1/2" min. D
•
Refer to web for detailed custom panel construction
and installation instructions.
9
/
" min.
7
8
10
1
/
" max.
Note: Refer to web
4
for detailed custom
panel construction and
installation instructions.
4
/
" min.
1
2
required
distance
to floor
Power cord
/
"
location (right
7
8
center rear)
Custom
/
"
3
4
Panel Specifications
Height
Width Thickness
11
/
"
30"
/
"min.
1
1
4
2
28
/
"
1
2
28
/
" min.
1
2
min.
28
/
" max.
3
4
28
/
"
7
8
max.
30" min.
9
/
" min.
7
8
10
/
" max.
1
4
Two 3" wide
x
/
" thick
3
4
planks must be
installed, capable
of supporting
200 lbs.
Warmer Drawer / Wall Oven
Combination Specifications
•
To support Wall Oven when using in combination with
Warmer Drawer, two 3"-wide x 3/4" thick planks must
be installed as a base, capable of supporting 200 Lbs.
Do NOT use full base, since planks are necessary to
allow for proper air displacement.
Combination Installations
•
Warmer Drawer can be used alone, or is approved to
be used in combination with any Electrolux ICON
Oven. (Refer to Combination Installation Specifications
and drawing on this page.)
•
Warmer Drawer is approved to be used in combination
with any Electrolux ICON
Microwave and / or Electric Single Wall Oven. (Refer to
model-specific Combination Installation Specifications
pages in Project Planning Section.)
28
/
" min.
23
/
1
5
2
28
/
" max.
24" max.
3
4
Full plywood
base required to
support 100 lbs.
Custom
panel
Mounting
panel
4" x 4" opening
to route armored cable
24" *
Bottom
(critical
of oven
dimension)
cutout
11
/
"
5
8
min.*
Electrical
junction box
location
®
High-Speed Oven / Built-In
e l e c t ro l u x i c o n . c o m
planning
information
" min.
For model:
8
E30WD75GTT
Note:
For planning
purposes only. Refer
to Product Installation
Guide on the web at
electroluxicon.com for
detailed instructions.
Specifications subject
to change.
Optional
Accessories
ServeWare
PN # 5304447729
®
Wall
57