Configuration > Link Aggregation > Port Trunking; Configuration > Link Aggregation > Lacp Port Settings - D-Link DES-1228 Manual

5 Configuration
Configuration > Link Aggregation > Port Trunking
The Trunking function enables the combining of two or more ports together to increase bandwidth. Up to
eight Trunk groups may be created, and each group can be consisted of up to eight ports. Select the ports to
be grouped together, and then click Apply to activate the selected Trunking groups. Two types of link
aggregation can be selected:
Static - Static link aggregation.
LACP - LACP (Link Aggregation Control Protocol) is enabled on the device. LACP allows for the
automatic detection of links in a Port Trunking Group.
Disable - Remove all the member in this trunk group.
Configuration > Link Aggregation > LACP Port Settings
The LACP Port Settings is used to create port trunking groups on the Switch. The user may set which ports
will be active and passive in processing and sending LACP control frames
Note: The default OUI for 3COM, Cisco, Veritel,
Pingtel, Siemens, NEC/Philips, Huawei3COM,
and Avaya is not common for all of their VoIP
devices.
Figure 58 – Configuration > Link Aggregation > Port Trunking
NOTE: Each combined trunk port must be
connected to devices within the same VLAN
group.
Figure 59 – Configuration > Link Aggregation > LACP Port Settings
D-Link Web Smart Switch User Manual
34