Table of Contents
Advertisement
To turn a channel on or off
• To turn a channel on, click the check box next to the channel number
Turn a channel on by
clicking the On check
box until a check
mark appears
Figure 31 Turning a Channel On or Off
To adjust the vertical offset
• Click and hold the left mouse button or touch screen stylus on the
• Click and hold the left mouse button or touch screen stylus on the
• Click the channel button in the vertical toolbar, then set the vertical
Agilent Infiniium 90000 Q-Series Oscilloscopes User's Guide
so that a check mark appears in the box. To turn a channel off, click
the check box again to clear it.
See Figure 31.
If you are not using a channel, you can turn it off. This simplifies the
waveform display and also increases the display update rate. When you
turn off a channel, the current vertical scaling factor and vertical scale
buttons for that channel disappear. They re- appear when you turn the
channel on.
You can also turn a channel on or off by using the Channel Setup
dialog box, or by using the front panel key for that channel.
Turn a channel off
by clicking the On
check box until the
box is cleared
waveform you want to move, then drag the pointer up or down to move
the waveform to the desired offset. Release when finished.
or
ground reference indicator for the waveform you want to move, then
drag the pointer to move the waveform to the desired offset. Release
when finished.
or
offset using the spin box control in the Channel Setup dialog box.
Using the Oscilloscope
63
3
Advertisement
Table of Contents
