Measurement Toolbar - Agilent Technologies Infiniium 90000 Q-Series User Manual

See more
measurements
Turn off any
measurements
that are running
(use Clear
display to
reset/restart
measurement
statistics)
Figure 19 Infiniium Oscilloscope Bottom of Display
To make it easy to see which controls affect each waveform, the
oscilloscope uses color consistently throughout the graphical interface.
These colors match the ones used on the front- panel channel inputs. For
example, the color of the waveform for channel 1 matches the color for
that channel. If channel 1 is the trigger signal, all of the trigger
configuration items, including the trigger level reference icon (at the right
side of the waveform display area), will match that color. The buttons
associated with that channel, vertical scaling and offset settings, ground
reference indicator, and measurements done on that channel also have the
same color.
The graphical interface is arranged so that the most common functions
affecting the waveform display are located around the edge of the
waveform viewing area. These include the measurement toolbar, horizontal
and trigger toolbar, and vertical toolbar.

Measurement Toolbar

The measurement toolbar contains icons representing the most commonly
used automatic measurements built into the oscilloscope.
Drag and Drop Measurements By dragging one of the measurement icons to
a waveform in the waveform display area, you can make that measurement
on the waveform. As you drag a measurement icon around the screen, the
icon outline changes color to match the color of the closest waveform. This
makes it easy to see which waveform will be measured when you drop the
Agilent Infiniium 90000 Q-Series Oscilloscopes User's Guide
Single
Run
Stop
Clear
display
Print
screen
Waveform
Brightness
Set
Set
horizontal
horizontal
scale position
(delay)
Access the
Horizontal Setup
dialog box
Using the Oscilloscope
Access
Set
the
trigger
Trigger
level
Setup
dialog
box
3
49