Table of Contents
Advertisement
3
Using the Oscilloscope
To set an edge trigger
1
2
3
4
5
Select Edge mode
Select the trigger
source
Figure 43 Setting an Edge Trigger
76
Click the trigger setup button at the bottom of the waveform display.
The trigger configuration dialog box appears. See
setup"
on page 75.
Click Edge.
Click the source you want to use for the trigger signal.
Click to select the rising edge, falling edge, or both edges for the trigger
source.
Set the trigger level using the spin box.
You can also click the trigger level setting to display a pop- up numeric
keypad, where you can enter the trigger level directly.
Agilent Infiniium 90000 Q-Series Oscilloscopes User's Guide
"To access the trigger
Select rising edge, falling
edge, or both edges
Set the trigger level
using the spin box
controls
Advertisement
Table of Contents
