Aastra AastraLink Pro 160 Administrator's Manual page 151

• Registrar Port
Supplied by your service provider. Specifies the port number of the remote
device (registrar server) on which SIP communications are received. By
default this is set to 5060.
• Username
Supplied by your service provider. A name (usually a phone number) you use
to connect to the service provider network. For example: 6174365000.
• Password
Supplied by your service provider. The password you use to access the service
provider network. For example: 15000.
• Caller ID
If provisioned, the specified Caller ID is used to override the default FROM:
address in the SIP signalling. Refer to
page
• Realm
Only required if requested by your service provider. Specifies the
Authentication domain within the destination network, where SIP call
steering to a specific media gateway is required.
• Authorization Name
Only required if requested by your service provider. Used to authenticate
during SIP registration using a different account name to the username.
• Outbound Proxy
Only required if your local network does not transparently route SIP calls to
the public SIP service provider. Used to route outgoing calls through this
device rather than direct to the registrar server.
• Outbound Proxy Port
Only required if using an Outbound Proxy. Specifies the proxy port on the
Outbound Proxy.
41-001190-01 Rel. 1.1, Rev. 00
Configuring AastraLink Pro 160 System and Network Parameters
4-49.
Configuring VoIP Settings
"Calling party identification" on
4-51