Specifying The Date And Time - Aastra AastraLink Pro 160 Administrator's Manual

Linux-based hardware unit
Hide thumbs Also See for AastraLink Pro 160:
Table of Contents

Advertisement

AastraLink Pro 160 Administrator Guide
Configuring System Settings

Specifying the Date and Time

If automatic time and date were enabled during the initial administrator setup of
the system (default set to yes during initial setup), the AastraLink Pro 160 uses the
Network Time Protocol (NTP) to synchronize its date and time from the Internet
global time servers. If Internet access is not available, then use the following
procedure to manually set the date and time for your AastraLink Pro 160.
AastraLink Web UI
Step
Action
1
Select Configuration->System->Set Date/Time.
2
In the "Date" field, specify the date that the AastraLink Pro displays on the IP phones in your network.
Default is 7 May 2008.
3
In the "Time" field, specify the time that the AastraLink Pro displays on the IP phones in your
network. Default is the current time set on the AastraLink Pro 160.
4
Click <Save> to save your changes.
4-8
41-001190-01 Rel. 1.1, Rev. 00

Advertisement

Table of Contents
loading

Table of Contents