Reinstalling Aastra Ip Phones At The Central Site - Aastra AastraLink Pro 160 Administrator's Manual

Reinstalling Aastra IP Phones at the Central Site

Use the procedure described in this section to reinstall an IP phone at the central
site that had been previously installed at a remote office.
The procedure described below resets the IP phone from "remote mode" to back
to "local mode." If you do not reset the IP phone, it will attempt to boot in remote
mode when you install it.
Step Action
1 Connect the Aastra IP phone to your Ethernet Hub/Router.
Note: See your AastraLink Pro 160 Quick Start User's Guide for instructions on setting up and
installing your Aastra IP phone.
2 Select <Cancel> when the IP phone UI prompts you to specify the IP address of the AastraLink
at your central site.
3 Press the <Options> key or button on your IP phone.
4 Use the arrow keys to view the options, then select <Factory Default>
5 Press <Show>
6 Enter the administrator password, then press <Enter>
7 Select <Default> when prompted to "Reset Phone Back to Factory Defaults."
41-001190-01 Rel. 1.1, Rev. 00
Remote Office Configuration of the IP Phone (Phone-Side)
Reinstalling Aastra IP Phones at the Central Site
Enter server name/IP
65.215.35.80
Backspace
Dot . Cancel
abc Done
Select Cancel
A-13