Media Card 32-Port Trunk Card Modem Connection - Nortel 1000 Fundamentals

Install ITG EMC shielding kit NTVQ83 with Small and Large System types.
Refer to
information on the cabling requirements.

Media Card 32-port trunk card modem connection

To provide remote access to the CLI for support and remote maintenance, a
modem can be connected to the serial port of the Media Card 32-port trunk
card. To configure a working interface, follow the steps in
"Connecting the Media Card 32-port trunk card modem" (page
Procedure 16
Connecting the Media Card 32-port trunk card modem
Step
1
2
3
Table 47
Modem Settings
Setting
ATS0=1 <return>
ATQ1 <return>
ATE0 <return>
AT&W0 <return>
4
Copyright © 2007, Nortel Networks
.
"ELAN and TLAN network interfaces" (page 205)
Action
Use a standard serial cable and establish communication with the
modem from a PC. Use the following settings:
• 9600 baud
• 8 data bits, 1 stop bit
• no parity
• no flow control
Ensure that a Hayes-compatible modem is used. From the command
line, type the following:
AT <return>
When the OK prompt appears, enter the required settings from
47 "Modem Settings" (page
Action
Set to auto-answer on first ring.
Disable result codes.
Disable local echo.
Save settings.
Connect the modem to the Media Card 32-port trunk card, using the
9-pin connector on the ITG Card ELAN/TLAN Adapter (L-adapter)
or the legacy ITG cable. The interface cable must conform to the
wiring specifications listed in
218) for compatibility with existing ITG modem connections.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
Cabling for the Media Card 32-port trunk card 217
217).
Figure 49 "Wiring specifications" (page
for additional
Procedure 16
217).
Table