Reset The Operational Measurements; Display The Number Of Dsps; Display Ip Trunk 3.01 (And Later) Node Properties - Nortel 1000 Fundamentals

Reset the operational measurements

This command resets all operational measurement (OM) parameters
collected after the last log dump.
At the ITG shell prompt, type:

Display the number of DSPs

At the ITG shell prompt, type the following command to display the number
of DSPs on the IP trunk card:

Display IP Trunk 3.01 (and later) node Properties

At the ITG shell prompt, type the following command to display information
about an IP Trunk 3.01 (and later) node:
The following IP Trunk 3.01 (and later) node information appears on the TTY:
•
•
•
•
At the ITG shell prompt, type the following command to display information
about an IP trunk card:
The command itgCardShow prints out the information that was
provisioned in TM 3.1, such as the IP trunk card TN, protocol used, card
role, IP addresses, and whether the DCH PC Card is on board. If the IP
trunk card is enabled, the status of the IP trunk card (Card Mode) and the
D-channel (DCH Status) is also displayed.
The following is an example of the itgCardShow command:
Index:
Type:
Role:
Leader IP: 47.11.215.182
RTP Base Port:
RTPHeaderCpmpresssion
Card IP: 47.11.215.186
Card MgtIP: 47.11.217.21
Ldr MgtIP: 47.11.217.21
Card TN: 9 0 0
Card State:
Copyright © 2007, Nortel Networks
.
Access the ITG shell through a maintenance port or Telnet 375
resetOM
DSPNumShow
IPInfoShow
IP addresses for the ELAN and TLAN network interfaces
default router for the ELAN and TLAN network interfaces
subnet mask for the ELAN and TLAN network interfaces
SNMP manager
itgCardShow
1
ITG2
Leader
2300,2300=>Default 173300+>Cisco
ENBL
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007