Configure Ip Trunk 3.01 (And Later) Data; Configure The Isl D-Channel On The System For The Dchip Card For Ip Trunk 3.01 (And Later) - Nortel 1000 Fundamentals

218 Install and configure IP Trunk 3.01 (and later) node
Figure 49
Wiring specifications
Configure IP Trunk 3.01 (and later) data
First, configure D-channels, Route Data Blocks, and trunks through the
system TTY. Then configure the ESN data blocks to implement the network
dialing plan and translations. Record the D-Channel, CHIDs, and TNs
for the IP Trunk 3.01 (and later) trunks on the IP Trunk 3.01 (and later)
Installation Summary Sheet.
To configure IP Peer Networking Virtual Trunks, refer to IP Peer Networking
Installation and Commissioning (NN43001-313). Record the first CHID for
the Virtual Trunks on the Virtual Trunk Installation Summary Sheet.
Configure the ISL D-channel on the system for the DCHIP card for IP
Trunk 3.01 (and later)
For the IP Trunk 3.01 (and later) application, use LD 17 to configure the ISL
D-channel for the DCHIP card in Large Systems.
LD 17 Configure the ISL D-channel for the DCHIP card (Large Systems)
Prompt Response
REQ CHG
TYPE ADAN
ADAN NEW DCH x
CTYP MSDL
Copyright © 2007, Nortel Networks
.
—End—
Description
Add new data.
Type of data block.
Action Device and Number, where:
x = 0-255
Multi - purpose Serial Data Link card type.
Set MSDL switch settings for the ISL DCH port to RS-422.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007