Configure Accounting Server - Nortel 1000 Fundamentals

250 Install and configure IP Trunk 3.01 (and later) node
7
8
9
Configure Accounting server
If a Radius Accounting Server is not used, skip this step. A Radius
Accounting Server collects call records from the IP trunk cards and
generates billing reports. Follow the steps in
Radius Accounting Server" (page 250)
Server.
Procedure 23
Configuring a Radius Accounting Server
Step
1
Copyright © 2007, Nortel Networks
.
The IP trunk card uses the addresses in the routing table entries to
route signaling packets over the ELAN network interface gateway
(router) on the ELAN subnet. Without routing table entries, the IP
trunk card routes signaling traffic over the TLAN network interface
gateway. Sending signaling traffic over the TLAN subnet can affect
voice quality.
Click Apply.
Click OK to exit the window.
To transmit the information to the node, from the menu select
Configuration > Synchronize > Transmit.
Action
Click the Accounting Server tab. See
tab" (page 251).
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
—End—
Procedure 23 "Configuring a
to configure a Radius Accounting
Figure 57 "Accounting Server