Nortel 1000 Fundamentals page 229

Prompt Response
...
STRI
WNK
STRO
WNK
SUPN YES
CLS (NHFD)/NHFA
DIP
...
Use the "NEW XX" command to assign DES equal to the IP trunk card
ELAN network interface IP address; for example: 10.1.1.1. For unit 0, use
CHG command to assign DES equal to the IP trunk card ELAN network
Copyright © 2007, Nortel Networks
.
Configure IP Trunk 3.01 (and later) data 229
Description
For nodes containing a mixture of 24-port and 32-port IP
trunk cards, determine the starting CHID by adding the
number of channels (ports) on the previous card to the
CHID of the previous card.
Example:
Leader 0: - 1 (24-port card)
Leader 1: - 25 (1 + 24) (32-port card)
Follower: - 57 (25 + 32) (32-port card)
The same First CHID must be entered in TM 3.1 (and later)
ITG ISDN IP Trunk Node Properties, Card Configuration,
"First CHID" field for this card. If this is not done, the trunk
unit seized by the core switch does not match the trunk unit
seized on the IP trunk card and the calls fall.
The standard First CHID matches the trunk route
member number for the trunk unit 0 in order to facilitate
administration and maintenance.
Start Arrangement Incoming.
Wink Start is preferred for IP Trunk 3.01 (and later).
Start Arrangement Outgoing.
Wink Start is preferred for IP Trunk 3.01 (and later).
Answer supervision is required.
(Deny)/Allow the Trunk Hook Flash feature over 911P
trunks.
Dial Pulse is required for IP Trunk 3.01 (and later) to avoid
busying multiple Digitone receivers when IP trunk card
faults occur.
Trunks must always be set to DIP. If SIG0 = ESN5 in the
RDB, the
Meridian 1/CS 1000M does not allow CLS = DIP in LD 14.
To avoid this problem and retain ESN5 signaling, set SIG0
= STD in RDB (LD 16). Then provision CLS = DIP in LD 14
for IP Trunk 3.01 (and later). After all trunks have been
programmed, in LD 16 change the RDB back to SIG0 =
ESN5.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007