Nortel 1000 Fundamentals page 226

226 Install and configure IP Trunk 3.01 (and later) node
Table 48
LD 16 NEW/CHG/OUT
Prompt Response
req
new/chg/out
type
rdb
cust
0-99
tktp TIE
M911P (NO)/YES
M911_ABAN (NO)/YES
M911_TONE YES/(NO)
ABTR (15)
Range 0-30
BRIP NO
DGTP PRI/PRI2
MODE PRA
IFC SL1
Table 49
LD 16 NEW/CHG/OUT for VTRK
Prompt Response
req
new/chg/out
type
rdb
cust 0-99
tktp TIE
M911P (NO)/YES
M911_ABAN (NO)/YES
M911_TONE YES/(NO)
Copyright © 2007, Nortel Networks
.
Description
Route Data Block.
Trunk Type.
M911 Trunk Type for MCDN Network.
Optional call abandon treatment:
YES = abandoned call treatment for route.
NO = no abandoned call treatment for route.
optional call abandon tone:
YES = tone given on answer.
NO = silence given on answer.
Timer (in minutes) to block the disconnect from being
tandemed across to the target node. Default value: 15
minutes. This timer value can be added in increments of
1 minute.
BRIP is set to NO by default, as this is not applicable to
911P routes.
Valid responses for this prompt are PRI or PRI2 if M911P
prompt is set to YES.
Valid response for this prompt is PRA if M911P if prompt
is set to YES, and VTRK is set to NO.
IFC is set to SL1 by default if M911P is set to YES. This
prompt is not configurable.
Description
Route data block.
Trunk type.
M911 trunk type for MCDN network.
Optional call abandon treatment:
YES = abandoned call treatment for route.
NO = no abandoned call treatment for route.
YES = tone given on answer.
NO= silence given on answer.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007