Nortel 1000 Fundamentals page 242

242 Install and configure IP Trunk 3.01 (and later) node
4
5
6
7
8
9
Copyright © 2007, Nortel Networks
.
Each Follower card can optionally have its TLAN network interface
IP address and TLAN network interface gateway IP address on a
different TLAN subnet than Leader 0 and Leader 1.
If Use separate subnets in the General tab was unchecked earlier,
perform steps a and b:
a. Enter the Management IP address (ELAN network interface IP
address).
b. Enter the Management MAC address ELAN network interface
MAC address). It is the motherboard Ethernet address. Find
it on the faceplate label of the IP trunk card currently being
configured. It is also identified as lnIsa0 on the card startup
messages and by the ifShow command in the ITG shell.
The TLAN Node IP and ELAN network interface gateway IP
addresses on the General tab and the ELAN network interface
IP address for Leader 0, Leader 1 and all Follower cards on the
Card Configuration tab must be on the same ELAN subnet.
Enter the Card TN. For Large Systems, the card TNs are validated
for loop, shelf and card separated by dashes. For Small Systems,
only the card number is required.
Select the Card Density from the drop-down list: 24 ports for an
ITG-P 24-port card; 32 ports for the Media Card.
Enter the ISL D-channel logical device number. The range is 0 –
255 for Large Systems; 0 – 79 for Small Systems.
If the card will be a DCHIP card, select the DCHIP is on this Card
check box. The DCHIP card must have an NTWE07AA DCHIP
PC Card with an NTCW84EA Pigtail cable installed and must be
connected to the ISL DCH port on the MSDL or SDI/DCH card.
The standard configuration is to put the first DCHIP PC Card on
Leader 1 and additional DCHIP PC cards on Follower cards.
Select a Protocol for the DCHIP card from the drop-down list. The
protocol selected must match the protocol configured in LD 16 in
the Route Data Block at the IFC prompt with respect to SL1, or
ESGF/ISGF QSIG interface (IFC), and in LD 17 at the IFC prompt
under ADAN DCH.
In LD 16, if SIGO is set to STD, select the SL1 protocol. If SIGO
is set to ESN5, select SL1 ESN5 protocol. In a mixed ESN5 and
non-ESN5 network, configure an ESN5 prefix for the non-ESN5 IP
telephony gateways by using the esn5PrefixSet command from
the ITG shell CLI. "Change default ESN5 prefix for non-ESN5 IP
telephony gateways" (page 271)
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007