Nortel CALLPILOT Installation And Configuration Manual page 33

May 2003
To remove the server cover
.
.
1 Remove the front bezel (see page 32).
2 Loosen the three thumbscrews at the rear of the top cover.
3 Remove the server cover by pulling the cover toward the rear of the
chassis, and then lifting it up and off.
4 Clip the lead from your ESD wrist strap to an unpainted metal section of
the chassis.
What's next?
Continue with "Inspecting the server interior" on page 35.
Part 2: 1001rp Server Hardware Installation
DANGER
Risk of electric shock
High current inside the chassis can cause severe injury.
CAUTION
Risk of equipment damage
Take precautions to protect internal components. Electrostatic
discharge (ESD) can render boards damaged or unusable. Wear
an ESD wrist strap.
Preparing for installation
33