Nortel CALLPILOT Installation And Configuration Manual page 70

Installing the server and connecting the peripheral devices
To connect the 1001rp AC server to power
.
1 Plug the server's AC power cord into the server's rear panel.
2 Plug the other end of the server's AC power cord into a properly
grounded power outlet or power bar.
70
CAUTION
Risk of personal injury and hardware failure
The power outlets that are used by the CallPilot server and its
peripheral devices must be connected to the same single-point
ground reference as the one used by the Meridian 1 switch or
Succession CSE 1000 system. If this requirement is not met,
power transients can cause personal injury and/or hardware
failure.
Standard 1.0
CallPilot