HP Surestore 64 - Director Switch User Manual page 119

Message
Error 213: Number of Zones Is
Zero
Error 214: A Zone Contains
Zero Members
Error 215: Zone Set Size
Exceeded
Error 216: No Attached Nodes
Exist
Error 217: All Attached Nodes
Are in the Zone
Error 218: Invalid Port Number
Error 219: Invalid Port Type
Error 222: Invalid SNMP
Community Index
Error 223: Unknown Error
Error 224: Invalid Argument
Error 225: Argument Does Not
Contain All USASCII
Characters
Error 226: Argument Is Too
Long
Error 227: Invalid SNMP
Community Name
Cause/Solution
The config.zoning.activateZoneSet command tried to activate
the work area; however, the work area is empty. Enter the
changes in the work area, and then reenter the
config.zoning.activateZoneSet command to activate the work
area to the fabric.
The config.zoning.activateZoneSet command tried to activate
the work area; however, the zone in the work area is empty. Add
at least one zone member to the zone, and then reenter the
config.zoning.activateZoneSet command to activate the work
area to the fabric.
The value entered for the SNMP community index is invalid. The
SNMP community index must be an integer in the range 1–6.
Enter an integer in the range 1–6.
The value entered for a parameter of the command is invalid. For
example, a letter may have been entered where an integer is
required. Enter a valid parameter for the command as described
in Chapter 2, CLI Commands.
Appendix 107