Config.switch.priority - HP Surestore 64 - Director Switch User Manual

Command Example
Root>
config switch prefDomainId 1

config.switch.priority

Syntax
priority switchPriority
Purpose
This command sets the switch priority.
Description
The switch must be set offline before this command is entered.
Parameters
This command has one parameter.
switchPriority
Specifies the switch priority. Valid values are:
neverprincipal
principal
of 1 becomes the principal switch; however, if two or more switches have a
priority of 1, the switch with the lowest WWN becomes the principal switch.
default
principal, the switch with a priority 254 becomes the principal switch;
however, if two or more switches have a priority of 254, the switch with the
lowest WWN becomes the principal switch.
neverprincipal
not able to become the principal switch.
Note that at least one switch in a multiswitch fabric must have a switch
priority value of principal or default.
Note that the number codes 2–253 are not now in use.
.
— sets the numerical switch priority to 1. The switch with a priority
— sets the numerical switch priority to 254. If no switch is set to
— sets the numerical switch priority to 255. This switch is
principal default
, , or
config 41