JVC RX-8040B Instructions Manual page 32

/Receiving Radio Broadcasts
You can browse through all the stations or use the preset function to go immediately to a particular station.
IMPORTANT:
Check the following before or while using the buttonsand controls.
For Zone 1 operations:
The ZONE 1 indicator lights up on the unit's display.
For Zone 2 operations:
The ZONE 2 indicator lights up on the unit's display.
• When using the unit:
-For Zone 1 operations: "ZONE2" is not shown in the unit's main
display.
-For Zone 2 operations: "ZONE2" is shown in the unit's main
display.
• When using the remote control:
When operating the receiver using the remote control, the
unit's display always shows the Zone 1 source information
though you are operating it for the Zone 2 source,
- Set the ZONE l/ZONE 2 selector to ZONE 1 or ZONE 2 correctly.
-Check the indication shown on the remote's display when you
press a button--this indicates the remote control operation mode
together with multi-room operation mode (either for ZONE 1 or
ZONE 2) for about two hours.
@ Q
J L _L
ZONE1 ZONE2 ZONE1 ZONE2
@ AUDIO POWER
ZONe1 Z_E2 W _*W_O CUD
I LJIVI_-F_ ]
[
Ex. When you press FM or AM
with ZONE l/ZONE 2
selector set to ZONE 1.
Ex. When you press FM or AM
with ZONE l/ZONE 2
selector set to ZONE 2.
' • J
cc_ ccb
OOo
1. Press FM or AM to select the band.
The last received station of the selected band is tuned in.
When operating for Zone 1
TUNED g.rEREO ALr[oMtr[h_,G.
F:" H
s_A_ _ ZONE2
VOLUME
I"m "1" "111' l'.'l l i ..... _ i_ I i_ I .::..," :......i i'ir"i......'.
When operating for Zone 2
T_ED STEREO AUTOMLqlNG
• .-i ..... i i r.- .".".
,:'. U "-iL:: ..:"
..................... VOLUME
i.- i':'i ":.4 .." % i':'ii-.i ":" _ [l_
2. TUning in to the frequency.
On the front oaneh
Pressing FM!AM TUNING • increases the frequency.
Pressing FM/AM TUNING • decreases the frequency,
On the remote control:
Pressing TUNING UP increases the frequency.
Pressing TUNING DOWN decreases the frequency.
Notes:
• When a station of sufficient signal strength is tuned in, the TUNED
indicator lights up on the unit's display.
• When an FM stereo program is received, the STEREO indicator
also lights up on the unit's display.
• When you hold the button (and release it) in step 2, the frequency
keeps changing until a station is tuned in.
• You can only select the same station of the same band (FM or AM)
for both Zone ! and Zone 2 operations, ff you change the station for
Zone 2, it also changes for Zone ! (and vice versa: indications on the
units display also change). This also means that if you change the
station for Zone 2 while recording a broadcasting program in Zone !,
recording in Zone ! will be interrupted.
30