JVC RX-8040B Instructions Manual page 11

Zone 1 speaker layout
Ideal speaker layout varies depending on the conditions of your
listeniug room. The diagram below is a recommended typical
example. Subwoofer
Left front speaker(s) Center speaker Right front speaker(s)
(L) (C) (R)
Left surround Right surround
speaker (LS) speaker (RS)
Surround back speakers (SB)
CAUTION:
Do not place the center speaker on the TV. If you do so, the center
speaker may cause various troubles to theTV (for example, color
unevenness). Moreover, it may hurt you by its falling from the TV.
Placing speakers
Front speakers (L/R) and center speaker ((7)
• Place these speakers at the same height from the floor, at or near
ear level.
• Array across the front of the viewing area.
Surround speakers (LS/RS) and surround back speakers (SB)
• Place these speakers at a position which is 60 cm to 90 cm
(2 ft to 3 ft) higher than the listener's ears.
• Point these speakers directly across the listening area, but not at
the listener's ears.
Subwoofer
• You can place it wherever you like since bass sound is non-
directional. Normally place it in front of you.
Subwoofer
* When only one speaker is connected for
the surround back speaker.
Note:
Ideal speaker layout requires that all speakers be placed at the
same distance from the listener. However, since in some places it
may be difficult to fulfil this requirement, this receiver can adjust the
delay time so that the sounds through all the speakers reach the
listener with the same timing. (See page 35.)
Enhance your audio system
You can use this receiver as the pre-amplifier (control amplifier)
when you connect power amplifiers to the PREOUT jacks on the
rear panel, using cables with RCA pin plugs (not supplied).
• Connect the white plug to the audio left jack, and the red plug to
the audio right jack.
I
Left front speaker Right front speaker
Power amplifier
It
Power amplifier
t
Center speaker
Power amplifier
Left surround Power amplifier
speaker
Surround back speakers*
Right surround
speaker
* When using only one surround back speaker, connect the speaker
as follows."
Power amplifier
Surround back speaker
9