JVC RX-8040B Instructions Manual page 31

I_M"_ ! l",h"l"_ l ,_ffl'_ p.,1 [.._ I
Before you start, rememhel'...
When shipped from the factory, both pairs of tile front speakers have
been set to be used ill Zone 1.
• To use the speakers connected to the FRONT2/ZONE2
SPEAKERS terminals, set the speaker usage correctly. (See
"Setting the Zone 2/Speakers 2 usage" on page 38.)
(i)
ZONE 1 ZONE 2
Set ZONE l/ZONE 2
selector to ZONE 2.
Press SPEAKERS ON/OFF 2/ZONE 2 to activate the Zone 2
front speakers.
The SPEAKERS ZONE 2 indicator lights up oil the display.
Press MUTING to mute the sound through the Zone 2 front
speakers.
• The VOLUME level indicator goes off from tile unit's display.
To restore the sound, press MUTING again so that tile VOLUME
level indicator appears on the unit's display.
• Turning MASTER VOLUME on the unit or pressing
VOLUME +/- on the remote control also restores tile sound.
I
The SPEAKERS ZONE 2 indicator lights up.
-" "" ' """ "" _ I_-1
.," i i r ,l i.,, ,," _
V_E
,-.. : : 1...
L.. i "..." L ."
To deactivate the Zone 2 front speakers, press
SPEAKERS ON/OFF 2/ZONE 2 again.
The SPEAKERS ZONE 2 indicator goes off from the display.
Note:
While the Zone 2 front speakers are activated, you can use only the
front speakers (plus subwoofer) for the Surround/DSP modes in
Zone !. Then the 3D-PHONIC prcessing (see page 43) is applied to
the Surround/DSP modes in Zone ! (the 3D-PHONIC indicator lights
up).
For those who connect the Zone 2 front speakers using the
ZONE 2 PREOUT jacks through another amplifier (see page
16)
To use the Zone 2 front speakers
l. Turn on the other amplifier connected to tile ZONE 2
PREOUT jacks.
2. Adjust the volmne level of the Zone 2 front speakers through
fills receiver.
CAUTION:
Be sure to turn down the volume:
Before turning on the speakers again, as its high volume may come
out of the speakers.
29