JVC RX-8040B Instructions Manual page 10

|l_o] i| i[_ _ li[i i _ i[;li'-'] i[_-I [(;,] I_ll_-Iil i i_-"_ il!iYLo[o} _,,a
You car] connect the following speakers:
• Two pairs of front speakers.
• One pair of surround speakers,
• One pair of surround back speakers,
• One center speaker.
• One powered subwoofcr.
CAUTION:
• Use only the speakers of the SPEAKER IMPEDANCE indicated by
the speaker terminals.
- When using only one pair of front speakers in Zone 1 :
Connect the speakers with an impedance of 8 _ to 16 _, and set
the "FRONT SPEAKER2" (see page 38) to "FRONT SPK2:SPK2".
- When using two pairs of front speakers separately in Zone 1
and Zone 2:
Connect the speakers with an impedance of 8 f_ to 16 f_, and set
the "FRONT SPEAKER2" (see page 38) to "FRONT SPK2:ZONE2".
- When using two pairs of front speakers only in Zone 1 :
Connect the speakers with an impedance of 16 _ to 32 _, and set
the "FRONT SPEAKER2" (see page 38) to "FRONT SPK2:SPK2".
• Do not connect more than one speaker to each speaker terminal.
For each speaker (except for a subwoofer), connect the (+) and
( ) ternEinals on the rear panel to the (+) and ( ) terminals
marked on the speakers,
Speaker connections
1 2
3
4
1. Cut, twist, and remove the insulation at the end of
each speaker signal cable (not supplied).
2. Turn the knob counterclockwise.
3. Insert the speaker signal cable.
4. Turn the knob clockwise.
IMPORTANT:
After connecting the speakers, set the speaker installation
information properly. You can use Quick Speaker Setup for it (see
page 32).
• To obtain the best possible Surround/DSP effect, see "Setting the
Speakers" on page 34.
Surround speakers
Surround back speakers* Right / Left
Center speaker
Front speakers 1
Right / Left
Front speakers 2
Right / Left
2 SPEAKERS RIGHT LEFT
'SURROUND BACK SPEAKERS • "SURROUND S PEAKERS •
I
--S
ENTER
:_EAKER
RIGHT LEFT RIGHT LEFT
O,C_V_DO' FRONT2/ZONE2
FRONT1 o rc.REno
_
SPEAKERS
1
FRONT1 OR FRONT2 : 80-160 1
]
ZONE2 : 8Q-160
FRONT1 ANDFRONTZ:16Q-3Z,Q
* When using only one surround back speaker, connect the speaker
as follows."
Surround back
speaker
CAUTION : SPEAKER IMPEDANCE :
o ,QE
!. L *,00,00, .PE,.ER, ,,
Connecting the subwoofer
You can enhance the bass by connecting a subwoofcr.
Connect the input jack of a powered subwoofcr to tire rear panel,
using a cable with RCA pin plugs (not supplied).
Powered Subwoofer
8