JVC RX-8040B Instructions Manual page 28

Zone 2 (Sub-room) Operations
This section explains only the operations used when you play a sound source in Zone 2 (sub-room).
See pages 19 to 25 for the Zone 1 (main room) operations.
• Before performing the Zone 2 operations, it is recommended to finish the basic settings on pages 32 to 3B.
IMPORTANT:
Check the following before or while using the buttons and controls.
For Zone 2 operations:
The ZONE 2 indicator lights up on the unit's display.
• When using the unit:
-"ZONE2" is shown in the unit's main display.
• When using the remote control:
When operating the receiver using the remote control, the
unit's display always shows the Zone 1 source information
though you are operating it for the Zone 2 source.
- Set the ZONE l/ZONE 2 selector to ZONE 2.
-Check the indication shown on the remote's display when you
press a button--this indicates the remote control operation mode
together with multi-room operation mode (either for ZONE 1 or
ZONE 2) for about two hours.
©
ZONE1 ZONE2
zo.Ei ZONE 2 W,_BS _D
TI!/ TI
J_llz I_1
Ex. WhenyoupressDVD withZONE1/ZONE2selectorsetto
ZONE2.
Note:
While the Zone 2 front speakers are activated, you cannot use the
center, surround, and surround back speakers for the Surround/DSP
modes in Zone !.
For those who connect the Zone 2 front speakers to the
ZONE 2 PREOUT jacks through another amplifier (see page
16)
To use the Zone 2 front speakers
l. Turn on the other amplifier connected to tire ZONE 2
PREOUT jacks,
2. Adjust the volmne level of the Zone 2 front speakers through
this receiver.
On the front panel:
.
I
.
.
:-- Z. /
4 °
__l L===J
Press _/I STANDBY/ON.
The STANDBY lamp goes oft', and the ZONE l irrdicator lights
up on the display.
• Tire buttons arrd corrtrols on tire unit work for Zone 1 operations.
The last Zone 1 source appears.
The ZONE 1 indicator lights up.
I
_ "., • ir'..
i...' '.,.' ;,.'
;:::' i i ':) i::) i"i i::" i::"
/....' '...' "". r.. ..... i i ,
The last Surround/DSP mode
appears.
¢ C D
The volume
level appears.
The currently selected SPEAKERS 1 arrd/or 2 irrdicator(s) also
light(s) up on tire display.
Press ZONE 2 ON/OFF to activate ZONE 2.
The ZONE 2 indicator lights up.
• When
connecting the Zone 2 front speakers to the
FRONT2/ZONE2 SPEAKERS terminals, see also "Setting
the Zone 2/Speakers 2 usage" on page 38, arrd "Activating the
Zone 2 Front Speakers" on page 29.
Press ZONE 2 CONTROL so that "ZONE2" and
the previously selected Zone 2 source name
appear on the display.
"ZONE2" appears.
":." ,=', i. i i=" .",
,::.. i.." l"[ l::..,::.
F', [ [ F',
_1 ...... i ..
The last Zone 2
source appears.
VOLUME
[_I t_-I I
I
The Zone 2 volume
level appears.
Now the buttons arrd controls on the unit work for Zone 2
operations,
• Each time you press tire button, the buttons and controls on the
unit are activated or deactivated for Zone 2 operations
alternately.
26