Download Print this page

JVC RX-8040B Instructions Manual page 13

Audio/video control receiver
Hide thumbs Also See for RX-8040B:

Advertisement

I
Cassette deck
I
You can conuect
either a cassette
deck or an MD recorder
to the
TAPE/MD
jacks. When connecting
an MD recorder,
see below.
Cassette deck
To audio input
(PLAY)
Right / Left
f
OUT
To audio output
MD recorder
]
You can connect
either an MD recorder
or a cassette
deck to the
TAPE/MD
jacks. When cormecting
a cassette
deck, see above.
Video
component
connections
Use tire cables
with RCA pin plugs (not supplied).
Connect
the white plug to the audio left jack,
the red plug to the
audio
right jack, and the yellow plug to the video jack.
• If your video
components
have S-video
(Y/C-separation)
arrd/or
component
video (Y. PB, PR) terminals,
connect
them using an S-
video
cable (not supplied)
or component
video
cable (not
supplied).
By using these jacks,
you can get better picture
quality
in the order:
[ Component
video > S-video
> Composite
video
]
• If your video components
have digital audio
output terminal,
connect
them using the digital cords explained
in "Digital
cormections"
(see page 14).
If your
video conrpenents
have an AV COMPULINK
jack
See also page 53 for detailed
irrt_rmation
about the cormection
arrd tire AV COMPULINK
remote
control
system.
IMPORTANT:
This receiver is equipped with the following video jacks--composite
video, S-video and component
video jacks.You can use any of the
three to connect a video component.
However, the video signals from one type of these input jacks are
transmitted
only through
the video output
jacks of the same
type.
Therefore, if a recording video component
and a playing video
component
are connected to the receiver through the video jacks of
different type, you cannot record the picture. In addition, if the TV and
a playing video component
are connected to the receiver through the
video jacks of different type, you cannot view the playback picture on
the TV.
MD recorder
To audio input
_
To audio output
Right / Left
f-
OUT
TAPE
IN
(PLAY)
Note:
When connecting an MD recorder to the TAPE/MD jacks, change the
source name to "MD," which will appear on the display when it is
selected as the source. See page 24 for details.
Video camera
]
The VIDEO
irrput
jacks
on tire front panel (inside tire front door) are
convenient
when connecting
arrd disconnecting
tire component
frequently.
,...
To audio
output
To composite video
output
_
_
t
;ToS-videooutput
: :
To optical digital output
_ITAL
S-VIDEO VIDEO
L--AUDIO--R
VIDEO
Video
camera
Note:
When using the digital input terminal, select the digital input mode
correctly. For details, see "Selecting the Analog or Digital Input Mode"
on page 22.
11

Advertisement

loading