JVC RX-8040B Instructions Manual page 12

When conuectiug individual componeuts, refer also to tire manuals
supplied with them.
• Analog connections
It" your audio componeuts have digital audio output temfinal,
connecting them using the digital cords explained in "Digital
connections" (see page 14).
Audio component connections
Use the cables with RCA pin plugs (not supplied).
• Connect the white plug to file audio left jack, and the red plug to
the audio right jack.
If your audio components have a COMPULINK jack
See also page 51 for detailed information about the connection
and the COMPULINK remote control system.
CAUTION:
If you connect a sound-enhancing device such as a graphic equalizer
between the source components and this receiver, the sound output
through this receiver may be distorted.
CD player
I
CD player
Turntable
]
output
CDrecorder ]
LA
CD recorder
Right / Left
9ut
L_
Right / Left
Turntable _,
: If a ground cable is
i
:, provided for your turntable
: connect the cable to the
...... * '_ screw marked (G) on the
To audio output rear panel.
Note:
This connection is for the turntable with an MM (moving-magnet) type
cartridge.
Any turntables incorporating a small-output cartridge such as an MC
(moving-coil) type must be connected to this receiver through a
commercial head amplifier or step-up transformer. Direct connection
may result in insufficient volume.
10