Removing Valve; Installing Valve Assembly - HAMPTON BAY Hamilton H15 Owners & Installation Manual

REMOVING VALVE

If your valve requires maintenance or replacement,
use the following instructions:
Note: Always close off the gas supply before
removing the valve.
1) If optional fan is installed, disconnect power
source to stove.
2) Remove access panel.
3) Disconnect gas line to stove.
4) Disconnect 3/8" NPT pipe from 90
on valve or fl ex connector.
5) Disconnect the two (2) switch wires from
valve.
6) Disconnect piezo wire.
7) Lift off Cast Top, remove Cast Front and remove
Glass Door. See the "Glass Replacement"
section for removal instructions.
8) Carefully remove the logs and embers.
Hampton® H15-1 Direct Vent Freestanding Gas Stove
9) Remove burner by removing the 2 screws
on each side, slide the burner to the left and
then lift the burner tray out.
Note: Use a magnetic type screwdriver if
possible.
10) Remove all 8 screws holding the burner tray
assembly in place. Remove defl ector.
o
elbow
11) Carefully lift the burner tray assembly out.
Screws
MAINTENANCE
12) To remove the valve, remove the 4 screws (2
per bracket) that hold the valve to the valve
bracket assembly.
13) To replace the burner tray assembly, simply
reverse these instructions.
To remove valve from valve assembly, continue.
14) Remove two (2) thermopile wires.
15) Remove thermocouple with a 9 mm (metric)
wrench.
16) Remove pilot nut with an 11 mm wrench.
17) Remove valve to orifi ce nut with a 13/16" wrench.
18) Remove inlet pipe with pipe wrench. Note
o
orientation of 90 elbow.
19) Remove two (2) phillips head M5 screws on
each side of the valve.
20) Remove valve and remove gas out 90
fi tting. Note orientation of fi tting.
INSTALLING
VALVE ASSEMBLY
1) To install a new valve assembly, reverse instruc-
tions for Removing Valve.
2) Check for leaks and manifold pressure. See
Gas Pressure Test instructions.
3) To reinstall valve, reverse instructions for remov-
ing valve assembly, steps 11-20.
o
brass
43