Removing Valve; Installing Valve Assembly - HAMPTON BAY H35-10 Owners & Installation Manual

REMOVING VALVE

If your valve requires maintenance or replacement,
use the following instructions:
Note: Always close off the gas supply before
removing the valve.
1) If optional fan is installed, disconnect power
source to stove.
2) Open the access panel and remove the valve
cover plate.
3) Disconnect gas line to stove.
4) Disconnect 3/8" NPT pipe from 90
valve.
5) Disconnect the two (2) switch wires from valve.
6) Lift off the Cast Top and lift out the front door.
7) Remove the cast front. (See page 13 for instruc-
tions).
8) Remove the glass front assembly by opening
the the 2 latches.
9) Carefully remove the logs, embers and rockwool.
10) Remove burner (see diagram below).
Note: Use a magnetic type screwdriver if possible.
11) Remove all 18 screws holding the burner tray
assembly in place.
12) Carefully lift the burner tray assembly out of
the unit to remove.
13) Replace with new valve assembly and reverse
elbow on
o
steps to reinstall. .
To remove valve from valve assembly, continue.
14) Disconnect the red, green and yellow wires
from the stepper motor as shown in the picture
15) Remove two (2) ignition cables from the IFC.
Disconnect the ignition wires from IFC,
connected to the valve
16) Remove pilot nut with an 11 mm wrench.
17) Remove valve to orifice nut with a 13/16"
wrench.
18) Remove inlet pipe with pipe wrench. Note
orientation of 90
19) Remove two (2) phillips head M5 screws on
each side of the valve.
20) Remove valve and remove gas out 90
fitting. Note orientation of fitting.
elbow.
o
brass
o
Hampton® H35-10 Direct Vent Freestanding Gas Stove
maintenance
INSTALLING VALVE
ASSEMBLY
1) To install a new valve assembly, reverse instruc-
tions for removing valve. See assembly steps
1-11.
2) Check for leaks and manifold pressure. See
Gas Pressure Test instructions.
3) To reinstall valve, reverse instructions for remov-
ing valve assembly, steps 14-20.
|
45
45
|