Removing Valve; Installing Valve Assembly - HAMPTON BAY H35-NG2 Owners & Installation Manual

MAINTENANCE
Replacing the Fan:
Reverse the above steps (1 - 4). Make sure the
fan wires and the ground wire are reattached.
Hint for pushing fan down onto pins - rub a
bit of dish soap on the grommet so it will slide
more easily onto the pin. Check to make sure
the fan is seated properly on the pins - try to
move the fan back and forth, there should be
no noise, if there is check that the grommets
haven't come loose.

REMOVING VALVE

If your valve requires maintenance or replace-
ment, use the following instructions:
Note: Always close off the gas supply before
removing the valve.
1) If optional fan is installed, disconnect power
source to stove.
2) Remove access panel.
42
3) Disconnect gas line to stove.
4) Disconnect 3/8" NPT pipe from 90
on valve.
5) Disconnect the two (2) switch wires from
valve.
6) Disconnect piezo wire.
7) Lift off the Cast Top and lift out the front
door.
8) Carefully remove the logs, embers and
rockwool.
9) Remove burner (see diagram below).
Note: Use a
magnetic type
screwdriver if possible.
10) Remove all 18 screws holding the burner
tray assembly in place.
11) Carefully lift the burner tray assembly out.
o elbow
12) To replace the burner tray assembly, simply
reverse these instructions.
To remove valve from valve assembly,
continue.
13) Remove two (2) thermopile wires.
14) Remove thermocouple with a 9 mm (metric)
wrench.
15) Remove pilot nut with an 11 mm wrench.
16) Remove valve to orifi ce nut with a 13/16"
wrench.
17) Remove inlet pipe with pipe wrench. Note
orientation of 90
18) Remove two (2) phillips head M5 screws on
each side of the valve.
19) Remove valve and remove gas out 90
fi tting. Note orientation of fi tting.
INSTALLING
VALVE ASSEMBLY
1) To install a new valve assembly, reverse
instructions for removing valve. See as-
sembly steps 1-12.
2) Check for leaks and manifold pressure. See
Gas Pressure Test instructions.
3) To reinstall valve, reverse instructions for
removing valve assembly, steps 13-19.
®
Hampton H35-2 Direct Vent Freestanding Gas Stove
o
elbow.
o brass