Removing Valve; Installing Valve Assembly - HAMPTON BAY H15-LP1 Owners & Installation Manual

REMOVING VALVE

If your valve requires maintenance or replace-
ment, use the following instructions:
Note: Always close off the gas supply before
removing the valve.
1) If optional fan is installed, disconnect power
source to stove.
2) Remove access panel.
3) Disconnect gas line to stove.
4) Disconnect 3/8" NPT pipe from 90
on valve or fl ex connector.
5) Disconnect the two (2) switch wires from
valve.
6) Disconnect piezo wire.
7) Lift off Cast Top, remove Cast Front and
remove Glass Door. See the "Glass Replace-
ment" section for removal instructions.
8) Carefully remove the logs and embers.
®
Hampton H15-1 Direct Vent Freestanding Gas Stove
9) Remove burner by removing the 2 screws
on each side, slide the burner to the left and
then lift the burner tray out.
Note: Use a magnetic type screwdriver if
possible.
10) Remove all 8 screws holding the burner tray
assembly in place. Remove defl ector.
o
elbow
11) Carefully lift the burner tray assembly out.
12) To remove the valve, remove the 4 screws
13) To replace the burner tray assembly, simply
To remove valve from valve assembly,
continue.
14) Remove two (2) thermopile wires.
15) Remove thermocouple with a 9 mm (metric)
Screws
16) Remove pilot nut with an 11 mm wrench.
17) Remove valve to orifi ce nut with a 13/16"
18) Remove inlet pipe with pipe wrench. Note
19) Remove two (2) phillips head M5 screws on
20) Remove valve and remove gas out 90
1) To install a new valve assembly, reverse
2) Check for leaks and manifold pressure. See
3) To reinstall valve, reverse instructions for
MAINTENANCE
(2 per bracket) that hold the valve to the
valve bracket assembly.
reverse these instructions.
wrench.
wrench.
orientation of 90 o elbow.
each side of the valve.
fi tting. Note orientation of fi tting.
INSTALLING
VALVE ASSEMBLY
instructions for Removing Valve.
Gas Pressure Test instructions.
removing valve assembly, steps 11-20.
o
brass
41