Network Setup - Kyocera TASKalfa 250ci Operation Manual

Network Setup

The following network settings are available.
• Checking Host Name ...8-73
• TCP/IP (IPv4) Setup ...8-73
• TCP/IP (IPv6) Setup ...8-73
• Protocol Detail ...8-75
• NetWare Setup ...8-76
• AppleTalk Setup ...8-76
• WSD Scan Setup ...8-76
• WSD Print Setup ...8-77
• Secure Protocol ...8-77
• IPSec Setting ...8-79
• LAN Interface Setup ...8-79
Checking Host Name
Check the host name of the machine. Use the procedure below.
1
Press the System Menu key.
2
Press [System], [Next] of Network. Check the host name displayed under Host Name.
TCP/IP (IPv4) Setup
Set up TCP/IP to connect to the Windows network.
Refer to TCP/IP (IPv4) Setup (by Entering IP Addresses) on page 2-13 about the procedures.
TCP/IP (IPv6) Setup
Set up TCP/IP (IPv6) to connect to the network. The default settings are "TCP/IP Protocol: On, TCP/IP (IPv6):
Off. Use the procedure below.
1
Press the System Menu key.
2
Press [System], [Next] of Network and then [Next] of TCP/IP Setting.
3
Press [Change] of TCP/IP.
4
Press [On] and then press [OK].
5
Press [Next] of IPv6.
6
Press [Change] of IPv6.
7
Press [On]. IP Address (Link Local) appears.
8
Press [OK].
9
After changing the setting, restart the system or turn the machine OFF and then ON again.
For detailed information on restarting the system, refer to Restarting the System on page 8-72.
8-73
Default Setting (System Menu)
8