Ohp Backing Sheet Mode - Kyocera TASKalfa 250ci Operation Manual

OHP Backing Sheet Mode

When two or three OHP transparencies are stacked on top of each other, static electricity may make them
difficult to handle. When using OHP Backing mode, a paper sheet is automatically inserted between each
transparency, making them easier to handle. Also, the same original page can be copied to the backing sheet
for multiple page copying.
NOTE:
Never load OHP transparencies into trays or cassettes other than the multi purpose tray.
When OHP Backing mode is set, the multi purpose tray paper type is automatically set to Transparency.
If the optional document finisher or 3,000 sheet document finisher is installed, you may need to specify the
output destination for finished copies. For further details, refer to Output Destination on page 4-11.
Blank Sheet
1
2
3
Original
Copied Sheet
1
2
3
Original
Follow the steps below for OHP Backing Sheet mode.
1
*
2
*
3
*
Copy
1
*
1
2
*
2
3
*
3
Copy
4-44
Outputs a blank backing sheet after copying to a
transparency. (* denotes OHP film.)
After copying to a transparency, copies the same
original image to the backing sheet paper. (* denotes
OHP film.)
1
Press Copy key.
2
Place the original.
3
Load the transparencies into the multi purpose tray.
IMPORTANT: Fan through the transparencies before
loading.
Up to 10 transparencies can be loaded at one time.
Be sure that paper of the same size and orientation as
the transparencies is loaded in the cassette.
Copying Functions