Troubleshooting
Solving Malfunctions
The table below provides general guidelines for problem solving.
If a problem occurs with your machine, check the checkpoints and perform procedures indicated on
the following pages. If the problem persists, contact your Service Representative.
Symptom
The operation panel does
not respond when the
machine is switched on
( | position).
The original size is not
detected properly.
4-2
Checkpoints
Is the machine plugged in?
Are the originals loaded correctly?
Is the machine installed beneath
fluorescent lights?
Corrective Actions
Plug the power cord into an AC outlet.
When placing originals on the platen,
place them face-down and align them
with the original size indicator plates.
Place originals face-up in the optional
document processor.
Do not install this machine beneath
fluorescent lights.
Reference
Page
—
Refer to
Operation
Guide Setup
Edition,
Chapter 2
Refer to
Operation
Guide Setup
Edition,
Chapter 2
—