Included Scanner Utilities
Registration method
1
Click the Scan. Setup button on the TWAIN Source main dialog box. The Scanner Setup dialog
box is shown.
2
Click the Edit button. The Address Setting dialog box is shown.
3
Click the Use Management Code check box to add a check mark.
4
To always use the same code, enter the desired Job code (8 digits or less) in the Code field.
5
Enter the same Job code entered into the Code field again in the Confirm Code field.
6
Click the OK button.
7
If a Job code is not configured, a Job code entry screen will be displayed during connection. Enter
the code to be used.
Unable to Connect to Scanner
One of the following problems may be preventing scanner connection. Try again after confirming the
scanner operation panel.
•
•
Maximum image size
Depending on available memory, scanning of certain image sizes may not be possible.
A3
A4
11 × 17"
8
3-46
The machine is currently copying or operating in a mode other than Wait for Scan mode.
Original has been loaded into the optional document processor before connecting TWAIN
Source to the scanner.
200 dpi
0.9 MB
0.5 MB
0.9 MB
× 11"
0.4 MB
1/2
300 dpi
400 dpi
2.1 MB
3.7 MB
1.0 MB
1.8 MB
2.0 MB
3.6 MB
1.0 MB
1.8 MB
600 dpi
8.3 MB
4.1 MB
8.0 MB
4.0 MB