Smtp Authentication - Kyocera TASKalfa 181 Operation Manual

Setting Scanner from a Web Browser
Display
Registration Button After entering New Password and Confirm New Password, click the
Reset Button
IMPORTANT: Always press the Registration button after making changes.

SMTP Authentication

When sending e-mail, sends an account name and password to the SMTP server for authentication.
The SMTP Authentication settings process is as follows.
NOTE: Once SMTP authentication (for administrators) has been configured, each user (up to 40)
can be added to SMTP authentication. (See page 2-12)
1
Enter the scanner's IP address into the Web browser to show the scanner home page.
2 Click System Basic Setting at the left side of the screen.
3 Click Enable.
4
Enter the Login Account Name to use in SMTP authentication.
5 To enter a new password or change a password, set Change Password to Yes.
NOTE: To skip changing the password, set to No and proceed to Step 8.
6 Enter the new password in the New Password field.
7 Verify the new password. Re-enter the password from Step 7 into the Confirm New Password
field.
8 Click the Registration button.
IP-Filters
This scanner includes a filtering feature to limit the IP addresses that can connect to each protocol,
restricting access to specific profiles to only specified IP addresses. For example, by setting HTTP
in IP-Filters, it is possible to only allow a specific IP address to connect to the scanner home page or
Address Editor.
Up to 4 IP address ranges can be filtered for each of the following protocols.
HTTP/Address Editor, TELNET, AdminManager, TWAIN
2-8
Description
Registration button to save the new password to the scanner. After clicking
the Registration button, an error is displayed if the entry under Confirm New
Password does not match the entry under New Password, or if the entry is
blank.
Click the Reset button to reset any changes to the setting options.