Understanding the printer menus
Use
Configure Log
Enable Audit
Yes
No
Enable Remote Syslog
No
Yes
Remote Syslog Facility
0–23
Severity of events to log
0–7
Disk Wiping menu
Disk Wiping erases only print job data on the printer hard disk that are not currently in use by the file system. All
permanent data on the printer hard disk are preserved, such as downloaded fonts, macros, and held jobs.
Note: This menu appears only when a formatted, non-defective printer hard disk is installed.
Use
Wiping Mode
Auto
Automatic Method
Single pass
Multiple pass
Set Date and Time menu
Use
Current Date and Time
Manually Set Date and Time
[input date/time]
To
Specify how and whether or not audit logs are created.
Notes:
•
Enable Audit determines if events are recorded in the secure audit log and
remote syslog. No is the factory default setting.
•
Enable Remote Syslog determines if logs are sent to a remote server. No is the
factory default setting.
•
Remote Syslog Facility determines the value used to send logs to the remote
syslog server. 4 is the factory default setting.
•
If the security audit log is activated, then the severity value of each event is
recorded. 4 is the factory default setting.
To
Specify the mode for disk wiping.
Mark all disk space used by a previous print job. This method does not permit the file
system to reuse this space until it has been cleared.
Notes:
•
"Single pass" is the factory default setting.
•
Only automatic wiping enables users to activate disk wiping without having to
turn the printer off for an extended amount of time.
•
Highly confidential information should be wiped using only the Multiple pass
method.
To
Show the current date and time settings for the printer.
Enter the date and time.
Notes:
•
For touch‑screen printer models, date and time are set in YYYY-MM-DD
HH:MM format.
•
Manually setting the date and time sets Enable NTP to No.
•
For non‑touch‑screen printer models, the wizard lets you set the date and
time in YYYY‑MM‑DD‑HH:MM format.
140