Backup Control Command (Stxvcopy) - Fujitsu ETERNUS VSS Hardware Provider 2.1 User Manual

Chapter 8 Commands

8.3 Backup Control Command (stxvcopy)

8.3 Backup Control Command (stxvcopy)
This command stops the copy session of the specified source disk.
Execute this command on a production server.
■
Format
"Installation folder"\bin\stxvcopy source-disk | mount-point stop [-f] [-t olu]
■
Description of options
Option
stop
-f
-t
■
Description of operand
Operand
source-disk
mount-point
olu
*1: Obtain the physical disk number according to the following procedure.
1. Start "Computer Management".
Click the [Start] – [Control Panel], then double-click [Administrative Tools], then [Computer
Management] to start.
2. Obtain the physical disk number of the target disk.
Click [Computer Management (local)] – [Storage] – [Disk Management].
The disk number of the target volume is the physical disk number.
*2: Specify the mount point using its complete path or drive letter.
*3: Use the "Backup Status Query Command" to acquire the OLU number of the Shadow Copy destination.
For details, refer to the Backup Status Query Command (stxvquery).
Stops a QuickOPC/SnapOPC+ session.
Stops a copy session forcibly.
This option is available only for QuickOPC operations.
When there are multiple copy sessions in the specified source disk, specify the OLU
number of the Shadow Copy destination for the target copy session to be stopped.
Specify the physical disk number of the source disk. (*1)
Specify the mount point of the source disk. (*2)
Specify the OLU number of the Shadow Copy destination. (*3)
Use a four digit hexadecimal number prefixed by "0x".
For example, when the OLU number is 1, specify "0x0001".
56
ETERNUS VSS Hardware Provider 2.1 User's Guide
Copyright 2012 FUJITSU LIMITED
Description
Description
P3AM-4582-03ENZ0