Fujitsu ETERNUS VSS Hardware Provider 2.1 User Manual page 55

Chapter 8 Commands
8.2 Update Volume Measurement Command (stxvtestcopy)
■
Description of operand
Operand
source-disk
mount-point
*1: Obtain the physical disk number according to the following procedure.
1. Start "Computer Management".
Click the [Start] – [Control Panel], then double-click [Administrative Tools], then [Computer
Management] to start.
2. Obtain the physical disk number of the target disk.
Click [Computer Management (local)] – [Storage] – [Disk Management].
The disk number of the target volume is the physical disk number.
*2: Specify the mount point using its complete path or drive letter.
■
Execution example
C:\>"C:\Program Files\ETERNUS VSS Hardware Provider\bin\stxvtestcopy"
start -p 1
stxvtestcopy successfully completed.
C:\>"C:\Program Files\ETERNUS VSS Hardware Provider\bin\stxvtestcopy"
status -p 1
source-disk
1
stxvtestcopy successfully completed.
C:\>"C:\Program Files\ETERNUS VSS Hardware Provider\bin\stxvtestcopy"
stop -p 1
stxvtestcopy successfully completed.
C:\>
■
Displayed contents
Title
source-disk
update
• Data backup is not performed while the amount of updates is being measured.
Specifies the physical disk number of the target source disk. (*1)
Specifies the mount point of the target source disk. (*2)
update
2
The physical disk number of the source disk is displayed.
The updated data amount after starting measurement is displayed in MB.
ETERNUS VSS Hardware Provider 2.1 User's Guide
Copyright 2012 FUJITSU LIMITED
Description
Description
55
P3AM-4582-03ENZ0