Fujitsu ETERNUS VSS Hardware Provider 2.1 User Manual page 41

Chapter 4 Environment Creation
4.1 New Installation
3
After installation, continue to set the environment. The following window appears.
4
Select "Stand-alone (Local copy)" and click the [OK] button.
When the [Skip] button is clicked, installation completes without the environment being set. Set a
Shadow Copy destination after the installation.
Refer to
5
The following window to register a Shadow Copy destination in the target disk pool
management file appears.
If multiple mount points or drive letters are allocated to one disk, one of them is displayed.
Select the disk that is to be a Shadow Copy destination from [Disk list] (multiple selections can
be made), and click the [--->] button and then [OK] button to register the disks in [Target disk list]
and [Used target disk list] in the target disk pool management file.
If the ETERNUS Disk storage system setup has not completed yet, click the [CANCEL] button.
"6.1 When Changing the Shadow Copy Destination" (page 45)
ETERNUS VSS Hardware Provider 2.1 User's Guide
Copyright 2012 FUJITSU LIMITED
41
for details.
P3AM-4582-03ENZ0